EZ1 Electric Sprayer

Before using the sprayer, ensure that the battery is charged completely.

Insert the battery into the compartment, ensuring the orientation is correct.

Attach the wand to the handle.

Attach the nozzle of your choice to the wand.

Turn the sprayer clockwise until it reaches the unlock indication located at the front of the sprayer.

Lift the lid from the tank so you can pour your solutions easily.

After filling the tank, close the liquid by turning it counterclockwise.

Press the power button at the handle of the sprayer. After spraying, press the power button again to turn it off.

Make sure to prime your sprayer before use.

To do this, try plugging the charger into the unit. If the unit is charging, the charger light will turn red. When doing so, make sure that you are plugging the charger into a working outlet.

Plug the charger firmly into the battery charger port on the base of the unit, then plug it into a 110v outlet. Your battery will last many years but may need to be replaced eventually.

If the spray is not coming out of the nozzle or the spray pattern is not as expected, inspect the nozzle for blockages or damage. Unscrew the nozzle and clean it thoroughly with water to remove any dirt or debris. If the nozzle is damaged, replace it with a new one.

Locate the battery port at the handle of your EZ1 sprayer.

Lift the cover to open the battery port.

Remove the battery from the sprayer’s battery port.

Then, insert the battery into the sprayer’s battery compartment.Make sure that it’ssecurely in place and properly connected to the sprayer’s electrical system.

Empty any remaining solution from the tank and rinse it thoroughly with clean water.

Fill the tank with a cleaning solution, such as water and vinegar or soap and water.

Pump the sprayer to circulate the cleaning solution through the hose and nozzle.

Let the cleaning solution sit in the tank, hose, and nozzle for 15-20 minutes.

Rinse the tank, hose, and nozzle with clean water and pump the sprayer to flush out any remaining residue.

Let the sprayer air-dry, and store it in a cool, dry place.

Add half a gallon of warm soapy water into the tank.

Make sure that you use warm water and that you are adding the right amount of soap. Ideally, you should add around 1-2 teaspoons of liquid soap.

For optimal performance, we recommend priming the sprayer by running it for no more than 10 minutes. This ensures proper function without putting unnecessary strain on the pump.

Close the lid and turn on the unit.

Make sure that you have tightly closed the lid. Depending on what's causing the issue, you could have flow coming out of your hose within a few seconds to a few minutes.

Run 2 gallons of warm water mixed with 2 teaspoons of liquid dish soap through the unit to clean all internal parts, then run 1 more gallon of warm water only through. Spray until the unit, wand & hose are fully empty.

You may plug your EZ1 unit in for constant battery maintenance, or if this is not possible, simply charge fully before storage.

Place the unit right-side-up in the warmest storage possible. Do not store long-term in temps below 32°F.

Storage in its original closed box is ideal, but if that’s not an option, you can cover it with a canvas or plastic tarp to protect it.